Subject: Tension bolt break and after market apex seals.
From: Rotary Engine
Date: 8/23/2006, 12:03 PM
To: AA-me


      >
      >
      > Perry Mick and I are working on a rotary ignition system that
      > will fire six or so times at 7500 RPM for each plug.
      > It is complicated but it will all be in one box.
      >
      > Perry, how is the transformer coming?
      >
      > Paul Lamar ...No rotor no motor.


     I am going to wind it today. I have a test board to install it in and
     start testing.

     Perry

     BTW how many hours did you have on that engine before the
     tension bolt broke?

     --
     Paul Lamar ...No rotor no motor.

     I bought the engine from a junkyard with all accessories in Jan.
     1997, it was still running in the car with rear end damage. 120,000
     miles. I don't know when the tension bolt broke because it was in an
     area that was not easily  inspectable at the time. I had 165 hours
     on the engine when it started losing coolant because the combustion
     pressure was blowing coolant out the pressure cap.

     I now have about 630 hours total, 465 on the Mazdatrix rebuild.

     I did not like the takeoff performance at 7000' density altitude in
     Utah, so I'm not doing those trips east again in mid-summer until I
     either get NOS for takeoff assistance, peripheral intake ports, or a
     variable pitch prop.

     Perry


Thanks Perry.

Here is a picture of Perry's rotor housing we took out of
the above junk yard engine with 165 hours in the air. Obviously
it had stock Mazda apex seals. I would not hesitate to put
this rotor housing back in a rebuilt engine. First picture.

Second picture is a rotor housing that
had only three hours on it with after market apex seals.


BTW The black carbon deposits are normal when running ordinary engine
oil to lube the seals. When 2 cycle oil or synthetic oil is mixed
with the fuel you don't get these deposits. They can be removed
with Scotch Bright and MEK solvent. Perry's rotor houseings had
very little carbon but I removed it with Scotch Bright anyway.

Paul Lamar

Ops I got the order of the pictures wrong when I attached
them. Here is the correct order. Perry's first.... damaged rotor
housing second.

BTW The damage is not severe enough to hurt
anything. Fortunately we discovered it early for unrelated
reasons. I am just shocked by the difference. With new stock
seals this rotor housing will be OK.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.