Paul - I do not remember seeing the original "Tension bolt break and after
market apex seals." E-mail.
Do you and your "airplane" people know about how we do the silicone on
tension bolts to prevent breaking???
We do it on all our "race" motors and should be done on ANY Rotary engine
that might stay at one rpm for any significant period of time -- where a
long tension bolt could sit at a vibration frequency and break.
For all but the two outside ones you just run a significant bead of silicone
(aerosol can type makes life easier) down the length (NOT on the threads) of
the bolt as it is fed down its hole. Then put a sufficient amount in about
the center of the outside two where they are near the housing. This
procedure "supports" the long part of the tension bolt, and should prevent
them from breaking from vibration.
Btw - this makes it MUCH harder to pull the bolts back out during
DIS-assembly, makes a big mess of old silicone pieces, and takes much longer
to clean the bolts for re-use.
Dave Lemon, Owner
Mazdatrix Inc.
2730 Gundry Ave.
Signal Hill, Ca. 90755
Phone: 562-426-7960
Fax: 562-426-9646
www.mazdatrix.com
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.