Subject: Tension bolt break and after market apex seals.
From: Rotary Engine
Date: 8/24/2006, 5:51 PM
To: AA-me




   Paul - I do not remember seeing the original "Tension bolt break and
   after
   market apex seals."    E-mail.

   Do you and your "airplane" people know about how we do the silicone on
   tension bolts to prevent breaking???

   We do it on all our "race" motors and should be done on ANY Rotary
   engine
   that might stay at one rpm for any significant period of time -- where a
   long tension bolt could sit at a vibration frequency and break.

   For all but the two outside ones you just run a significant bead of
   silicone
   (aerosol can type makes life easier) down the length (NOT on the
   threads) of
   the bolt as it is fed down its hole. Then put a sufficient amount in
   about
   the center of the outside two where they are near the housing. This
   procedure "supports" the long part of the tension bolt, and should
   prevent
   them from breaking from vibration.
   Btw - this makes it MUCH harder to pull the bolts back out during
   DIS-assembly, makes a big mess of old silicone pieces, and takes
   much longer
   to clean the bolts for re-use.

   Dave Lemon, Owner



I  can personally attest to the mess on disassembly part.  I'm still
cleaning little bits of black RTV out of everything where I tore the
engine down.  A wire brush on the grinder got through it all & cleaned
up the bolts eventually.

Mark Supinski



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.