Subject: Boring P Port holes
From: Rotary Engine
Date: 8/29/2006, 8:40 PM
To: AA-me


Paul,
As of today I have bored p ports both ways, straight thru one size
and/or  with a shoulder.  Of the two, the shoulder version finishes
off perfectly inside the housing as you have said  and for that
reason I think it is better.  I am happy to report my  little fixture
was adequate.  No vibration at all even when I hit it with big
tooling.  This time I bored a 1.5" dia hole with a six flute HSS end
mill  and then finished with the boring head.  The job went slowly
due to the amount to be removed.  If I end up doing more of these, I
will buy a 1.75" mill.   Other than that, no problem.    If anybody
wants to do their own, I will be glad to offer verbal assistance.  I
do not have any 2" aluminum tube so I stuffed a steel exhaust bend in
the hole to see how it looked.     Not bad.      Jerry

Sorry about the clutter.  That is how my desk always looks.


Good work Jerry. How much would you charge?
I think it would go faster if you drilled it one inch dia. first
to give clearance for the end mill center.

Paul Lamar ...No rotor no motor.


Paul

Preparing to order some AL. pipe today I found metric sizes are much
different.


Here are the sizes in 6063T pipe
Inch sizes in [  ]

 OD              wall thickness         ID.

50 [1.968]         1.0  [.039]          48 [1.89]
50 [1.968]         1.5  [.059]          47 [1.85]
50 [1.968]         2.0  [.078]          46 [1.81]


55 [2.165]         2.0  [.078]          51 [2.0]  *  Lemans size
55 [2.165]         3.0  [.118           49 [1.93]



I believe I have to chose between the latter two.  I like the fact of
drilling a step into the housing as the bottom of the pipe  seats well.  I
am not sure about JB Weld though  We don't have that stuff over here but I
did send them a letter asking for them to send me some.

My concern is not about the holding strength of the epoxy but more about the
inherent expansion properties of the material itself since it is being used
to act as a water barrier as well as bond to the aluminum pipe and  housing
in three or four interfaces.

Here is a link where you can access their website and download a PDF file on
the ingredients. http://jbweld.net/techinfo/index.php

I heard you mention it contained some iron powder but their is also a high
percent of calcium carbonate. (plaster?)

Any chemical engineers incline to comment?

DougFir


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.