Paul,
Do you have a rough idea how deep these grooves are? Although the picture
shows a water passage on the upper right without grooves can I assume that
this picture was taken before they were ground out?
This information came at a great time. I'll pick up several some junk
housing today to play with.
DougFir
My guess they are around 1/8 inch.
--
Paul Lamar ...No rotor no motor.
Paul,
How would you grind those grooves? By hand with a rotary tool?
I guess the idea is increased surface area exposed to coolant -- like fins
on air cooled engine?
Regards,
Gordon.
It has been done by hand in the past but it could be done
on an NC mill. Perhaps with a custom cutting tool.
Mazda them self selves machined away a ridge for the 280 HP
turbo charged 3rd gen RX7 rotor housings.
The big question in my mind is how does that change the distorted
shape of the housing as it warms up. The apex seal already has a slight
crown to conform to the distorted rotor housing wear surface.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.