Regarding the shape of the port at the inner surface of the housing.
If the port is drilled straight (parallel to the horizontal center
line) the port will be oval. At 1.8750 dia. it is much narrower than
the exhaust port and should not cause any problem with the seals. If
the port is drilled perpendicular to the housing than it should be
circular I would think. How would one create the "D" shape. Die
Grinder? Sounds scary to me. One slip and the housing is junk. Or
the insert could be made thick enough that the port shape could be
ground in it before it is installed in the housing. Jerry
All true Jerry. I am happy with 240 HP. That is far more
HP than any piston aircraft engine anywhere near its weight.
-- Paul Lamar ...No rotor no motor.
Paul and Jerry,
If the port is drilled perpendicular to the housing the result only
circular to the centerline. The bore parallel to the horizontal housing
center plane probably flows better. I have included the jpeg of two
bored housings. The horizontal and perpendicular bores are the same size
and are centered on the same point on the inner face. The horizontal
penetration would have a longer port timing, with a later opening. FWIW
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.