Thanks. I would think the ribs would increase the young modulus number and
make the housing stiffer. Same reason an H beam is stiffer than a flat bar.
Doug,
One of the best mechanical engineers I ever worked with stated a
general rule, "Removing material always weakens a structural shape."
There are some specific exceptions, but not many. I agree with Paul that
the housing is weakened by the slots. What you are thinking about may be
a bar and I beam of the same weight. in that case the I beam would
generally be stiffer, but the profile of the I beam would be
considerably taller. What is being attempted on the pictured housing is
obviously increased coolant contact area. It might be argued that slots
aligned axially with the e-shaft would increase the area without
impeding the flow as much. That profile would reduce the cross-sectional
area and weaken the housings more than the radial slot though.
Bill Jepson
Thanks Bill,
I see. You answered my next question as well as that is the reason the
upper part of the rotor housing water passage way is not grooved. I think
Paul and Francious are right. I should be prepared to take this engine
apart a lot to get the cooling correct. I see if you can reuse the Mazda
seals that are in it before getting fancy ceramic seals.
Even though I will only use 300 Hp for about 5 minutes at a time on
take-off I am trying to be conservative and over size (I hope) cooling heat
exchangers. Presently I have room for heat exchangers (not including the
end tanks) of 1.5" X 8.25" X 30.5" times two in parallel which is a total of
755 cubic inches. Each will have rammed air delivered to them. Air comes
in from cup scoops on the cowling side and exits out the top rear through a
cowl flap. The 7.5" X 13 Sebrab oil cooler is planned for mounting under the
engine at a slight angle in front of the sloping oil pan. It also has a
dedicated rammed air inlet and outlet under the cowl. Total for oil heat
exchanger is 195 cubic inch. Total for both is 950 cubic inches. I believe
I have the room to make some efficient ductwork according to the K&W notes
Paul has supplied. To test it so I am now considering making a small booth
around the engine with the cowls on and have the PSRU soft connected to an
industrial fan.
Even with a 3:1 ratio and the engine at full chat, the fan in fine pitch
would get up to 2700 rpm or so. The fan would have to be kept under 74"
dia. Of course the issue of departing blades has to be considered.
Don't know if it would work but it sure would be a nice situation to load
test the engine with variable pitch fan blades and have a climb speed air
flow of 90 knots passing through the chamber as well.
DougFir
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.