Subject: Axial Flow supercharger ,being developed for the Renesis...
From: Rotary Engine
Date: 9/3/2006, 10:21 PM
To: AA-me


Just in case some of you haven't heard of the Axial Flow supercharger
being developed for the Renesis...

http://www.axialflow.com/products.htm

Joe



Hi Y'all,
can anyone shed some light on the flow characteristics of an axial
supercharger?

What is the plus/ minus  argument?

How does it compare to the Lysholm whipple charger we  looked at
recently?

I understand axial flow compressors as an ex jet jockey, but as part of
a gas turbine; Pumping air into a car engine is a different matter.
Has anyone on here had experience with this type of blower?

There is precious little detail on the website.
With thanks, Dave McC




Dave,

That axial compressor has my curiosity piqued too. I checked out the
website
and found no data of any kind -- although the "history" section did
provide
a bit of back story on how this company and product came about.

I filled out the request info form, asking for data on adiabatic
efficiency,
compression ratio, rotation speed, etc. However, I'm not sure that the
form
worked -- I got a page of gibberish each time I clicked send.

If I don't hear back I will call them.

An axial compressor should be pretty efficient both in terms of power used
and heating the charge. I'm no supercharger expert, but I would think
that,
in general, an axial compressor should be more efficient than a
centrifugal
compressor, which has the disadvantage of slinging the air to the outside
and also changing the direction of flow by 90 degrees.

I think most of the high-performance turbofan engines are using all-axial
flow compressor stages -- a good example being the Citation X.

Regards,

Gordon.


If you have some serious time on your hands, this is where the bulk of the
Axial Flow supercharger discussion has taken place....with Richard Paul
actively participating in the info, and banter....

http://www.rx8club.com/showthread.php?t=29778

I am sure this is the largest thread on the RX-8 forums, with almost 4000
posts, and almost 300000 views...

I am looking forward to this design, as I am one to go for the unusual and
intruiging engineering designs...a perfect compliment to my Renesis!

If you notice he is developing the unit for the Honda S2000 and the
RX-8....both 9000 rpm machines.... I am assuming, like many turbofan
applications, that this benefits from spinning very quickly!

Unfortunately I cannot make it to Irvine Mazda HQ for seven stock 9 this
year, as I would love to see this thing in action...It is supposed to be
for sale at that point too (late Oct.)

Joe


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.