Subject: slide throttle parts source]
From: Rotary Engine
Date: 9/9/2006, 10:35 PM
To: AA-me




     Does anyone have a copy of email a couple of weeks ago that
     had mcmaster carr part #'s and so on that you could forward .

     Thanks ,Geir

      > This is the method we use for attaching the 10-32 throttle
      > cable to the Teflon. These are off the shelf 3/8th steel spacers
      > from McMaster Carr.
      > http://www.mcmaster.com/
      >
      > McMaster Carr 3/4 inch OD 3/8th inch long 5/16th ID steel spacer part
      > number 92415A455 $3.32 well worth it. Page 3001 cat 108
      >
      > Also buy the precision ground blanks in Teflon. McMaster Carr
      > part number 9711K2 for 3/8 thick 4 inches wide and 12 inches long.
      > Expensive but well worth it. +-.005 Page Page 3282
      > cat 108
      >

     Make subject folders guys and move stuff to folders.

     Paul Lamar ...No rotor no motor.
     -------------------------------------------------------------

     Paul,
     McMaster On Line catalog is no longer listing the precision ground
     Teflon, 3/8x4x12".  Either 2x12 or 12x12", see below.

     Joel


--------------------------------------------------


I'll see if I can screen capture the page.

Paul Lamar ...No rotor no motor.

OK looks like you are going to need to buy the 1/2 thick
and face it off both sides on a mill to .375 thick.
+/- .04 is too sloppy.

Paul Lamar ...No rotor no motor.

Ops wrong page. You can still get +/- .005
you just have to buy a 12 by 12 sheet as Joel stated.
At $152. Will make 3 slides.
Part number 9711K26

Is getting late.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.