A picture of the inside of the rotor housing would not do you much
good unless it was taken exactly aligned with the port center line.
That would take a camera that could focus in a few inches. Most
cameras need at least 1.5' to focus. With Paul's style of ports there
is no dog leg so you could take it from outside the housing.
The hole comes through a curved surface. With an off axis picture
the shape would not be telling of what is really there.
Purely speculation, but I bet that the hole is round and the
optical illusion created by the intersection of the hole with the
curved surface is what make people think it is not round. Of course I
wouldn't bet much.
This thread has pics (bottom of the page) of some Mazda Factory Racing
housings - both rectangular and D shape.
What Lemans used is anyone's guess.
http://www.rx7club.com/showthread.php?t=144200&page=26&pp=15
Cheers
Cary
Thanks Cary,
I will forward them to my Mazda friend and see what he has to say. His
research notes he once gave me stated the intake port as having a 200mm2
area. A 2" ID works out to 203mm2 or 1.998" The entrance to the
housing
area is given as 51mm or 2.007"
Yes Paul I am splitting hairs:) I realize we don't need a engine to
rev up
to 9,500 rpm. which was the ultimate design limit of the that engine
at the
time.
Academically speaking though and for the those 4 rotor Reno racers
wanna-bes
out there, if I am looking at it correctly, the D shape shown in the
picture
opens slowly but closes abruptly.
The D port shuts like one would expect a compressor valve to shut.
That is
suddenly. I have designed PSA oxygen generators in my past life before I
became a rotorhead and accurate timing and speed of valve closing was
paramount between getting 98% purity or only 90%. The compressor, the
reaction chamber volume and zeolite medium were the same in both cases.
As for opening characteristics in the D shape, it would be the same as a
straight in oval shape which I guess minimizes the overlap?
About the advantage of the rectangular port I haven't a clue. I only
heard
the D shape was used for track racers over here so you would think the
local
Japanese learned it from their mentors.
Doug Fir
Hi Doug;
If someone has a pic or dyno result that could resolve the Lemans
porting mystery I would be interested :)
All Pports have significant overlap - take a look at:
http://www.yawpower.com/dectech.html
Paul occasionally posts a picture from the Mazda papers of the measured
intake/exhaust pressures
relative to standard pressure. It shows lots of dynamic effects of all
the port open/close events
and reflections.
The abrupt close of the D shape intake port was probably chosen to
maximize airflow over an rpm range.
The Dport rotor volume would already be past BDC (decreasing in volume)
with the higher up/later closing.
This would of course vary with rpm, intake velocity and airflow momentum
(pipe diameter), pressure (turbo),...
The D shape close should also give a sharp reflection wave that could be
utilized later in a tuned system.
The rectangular ports are probably best for max HP at very high rpm with
minimal resistance and longer port
open times.
Cheers
Cary
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.