Does anyone have a copy of email a couple of weeks ago that
    had mcmaster carr part #'s and so on that you could forward .

    Thanks ,Geir

     > This is the method we use for attaching the 10-32 throttle
     > cable to the Teflon. These are off the shelf 3/8th steel spacers
     > from McMaster Carr.
     > http://www.mcmaster.com/
     >
     > McMaster Carr 3/4 inch OD 3/8th inch long 5/16th ID steel spacer part
     > number 92415A455 $3.32 well worth it. Page 3001 cat 108
     >
     > Also buy the precision ground blanks in Teflon. McMaster Carr
     > part number 9711K2 for 3/8 thick 4 inches wide and 12 inches long.
     > Expensive but well worth it. +-.005 Page Page 3282
     > cat 108
     >

    Make subject folders guys and move stuff to folders.

    Paul Lamar ...No rotor no motor.
    -------------------------------------------------------------

    Paul,
    McMaster On Line catalog is no longer listing the precision ground
    Teflon, 3/8x4x12".  Either 2x12 or 12x12", see below.

    Joel


--------------------------------------------------


I'll see if I can screen capture the page.

Paul Lamar ...No rotor no motor.

OK looks like you are going to need to buy the 1/2 thick
and face it off both sides on a mill to .375 thick.
+/- .04 is too sloppy.

Paul Lamar ...No rotor no motor.

Ops wrong page. You can still get +/- .005
you just have to buy a 12 by 12 sheet as Joel stated.
At $152. Will make 3 slides.
Part number 9711K26

Is getting late.