I used 1 1/2 X 1/4 bar stock on the sides and rear and needed 2 X 1/4
inch stock for the front. The sides are 1/8" and the bottom, front and
rear is bent up .080". After getting the flange frame welded I brought
it home to use the stock oil pan to drill the mounting holes and fit up
the rest of it.  It is 2 1/2 inches deep in the front and 4 inches deep
in the back and holds a little more than six quarts. The drain is on the
right rear side.  Karibian


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.