Paul
Some more information. Pity nobody told anybody about this problem.
Perhaps you could add it to the Rotary website.
I would recommend that no transistor device be subjected to under cowl
heat. The coil packs could be mounted in the cockpit along with the fuel
pumps. If coiled wire type ignition leads, the same as the Mazda (Bosch
super) were used the extra length would not matter.
Ian
Hi Ian,
No objection to forwarding to Paul's list.
Sound's like you have the correct version software in your EC2.
Different coils seem to have different tolerance to heat but in general,
cooler is always better. The D581 type LS1 coils are the most sensitive
seen so far. At 5600 rpm, they will fail in short order if the air temp
around them gets much above 130 F. I have proven this on 3 separate
occasions. To prove to myself that the temperature was the critical
factor, I am running 3 D581s (and one D580) but now have them inside an
enclosure fed with a cool air blast tube. No failures on any of them
after 200 hours now. I am using the RX-8 coils on my 20B but have no
in-flight run time on them. I have run them on bench with engine
simulator at 6000 rpm and they do get pretty warm but have not failed
(at room temperature).
Tracy
Thanks Ian and Tracy for all this info. I'll add it to the
Web site under
http://www.rotaryeng.net/ignition.html
and the fact the rotary fires its coils twice as often
as a piston engine.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.