Subject: JB Weld hot water test.
From: Rotary Engine
Date: 9/16/2006, 1:42 PM
To: AA-me

OK folks here is a suggested test device.
I'll make the end caps on my lathe and JB Weld
them to the tube section. I'll install a tubeless tire
valve to pressurize it and a pressure gage fitting
on the other end. Then I will boil it for a couple
of hours, pump it up and see if it leaks.
Then put it in the freezer for a few hours. Take it out and
pump it up again and see if it leaks.

Can anybody think of any changes in the configuration
they would like to see?
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.