OK folks here is a suggested test device.
I'll make the end caps on my lathe and JB Weld
them to the tube section. I'll install a tubeless tire
valve to pressurize it and a pressure gage fitting
on the other end. Then I will boil it for a couple
of hours, pump it up and see if it leaks.
Then put it in the freezer for a few hours. Take it out and
pump it up again and see if it leaks.
Can anybody think of any changes in the configuration
they would like to see?
--
Paul Lamar ...No rotor no motor.
What about a couple of eyes on the caps so you can apply a
shear load. Hook one end to an engine hoist and pick up a
ton with the other end.. Load it to
failure after 100 cycles or so.
John
The load is on the caps when it is pressurized.
At 30 psi the loads on the caps are 94 pounds.
The shear stress on the 1/2 inch wide epoxy strips
is about 30 psi.
That however, is not what we are testing here.
We want to see if the epoxy will stay sealed
after being repeatedly boiled and frozen.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.