Subject: JB Weld hot water test.
From: Rotary Engine
Date: 9/16/2006, 10:12 PM
To: AA-me


   OK folks here is a suggested test device.
   I'll make the end caps on my lathe and JB Weld
   them to the tube section. I'll install a tubeless tire
   valve to pressurize it and a pressure gage fitting
   on the other end. Then I will boil it for a couple
   of hours, pump it up and see if it leaks.
   Then put it in the freezer for a few hours. Take it out and
   pump it up again and see if it leaks.

   Can anybody think of any changes in the configuration
   they would like to see?
   --
   Paul Lamar ...No rotor no motor.

   Paul,


   Put anti freeze in the tube, then pressurize and boil it since that is
   what it will be sealing, not just pure water. I tried to seal a leak in
   an auto AC system with JB-Weld and the R-134 would leak through in a few
   hours.

   Ed. Sadler
   -----------------------------------------------------------------

   Ed,

   I,ve made a few seals with JB weld on aluminum AC parts.   I've
   found that the repair area must extremely clean and degreased as the
   refrigerant oil in the system will interfere with getting a good bond.

   Joel



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.