Subject: Adapting Tracys PSRU to stock bell housing -cush drive
From: Rotary Engine
Date: 9/17/2006, 6:12 AM
To: AA-me

Paul

I was going over your rendering of Tracy's redrive mounted to the
Bell housing. I think (can you see the smoke?) I may have found a
more elegant way of mating the two together. Now keep in mind, these
are rough (not to scale) and may have to be modified a bit but the
general idea is there. I went to Doug Muelllers hanger tonight and
finally took a good look at Tracy's redrive.We set the redrive on
the bell housing and measured about 4"in that the shaft would have
to be extended in order to bolt the plate that is supplied with the
redrive to the top of the bell housing, Well I'm afraid to ask Tracy
to make one, he'll probably say "no" and  it's going to cost alot of
money.

While I was driving home it hit me this is what I came up with,
 very simple and you can use the bell housing without modifing the
redrive wiht the exception of cutting down the redrive plate and of
course you will have to take apart Tracy's spline drive to mate up
 with the new cushdrive.  The torsion plate from the redrive is cut
in a circle to fit on the outside of the  housing then you simply
 drill new holes in the plate to match up with the holes in the top
of the bell housing.

I have 2 different ideas on how to make this
work the one is simply putting a spacer between the spline coupling
and reattaching it with bolts instead of the rivets. the other is
using the rubber mounts Tracy supplies with the redrive, counter sunk
 into the the spacer in the back and attaching the spline coupling
to the front using rivets. the first one you won't change the
componets supplied by Tracy you simply add the spacer. the other
is a little heavier and a little more money but alot beefier.

Tony Long EZ

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.