I think this is it
Tony
Yes much more practical Tony. Drilling a whole bunch of holes
4 inches deep would take forever.
I like this one much much better. See... those nuts were not all
that hard were they? :)
Paul Lamar
------------------------------------------------------------------------
Tony,
If you haven't acquired the drive yet, I would give Tracy a call and ask
him about the extended shafts. He stated two or three months ago that
he intended to begin offering some shaft length options for a small
extra cost.
Your idea is a good one. But, there may be some unexpected dynamic
effects caused by moving the spline coupling flange this far off the
plane of the isolation plate. If there is any imbalance the PSRU input
shaft will experience a cantilever load. Some resonance effects could
occur in the isolation plate. Tracy's isolation plate has worked pretty
well so far. You would be introducing some new unknowns with this
scheme. I'll bet that when Tracy sees your drawings, he will be even
more motivated than before to offer some shaft length options! Give him
a call.
Tracy should offer a pre-drilled adapter plate and shaft for each type
of Mazda bellhousing. I don't know how many there are. Do you know,
Paul? The cost saved on the smaller (and maybe thinner) adapter plate
would partially offset the additional cost of the shaft.
Aubrey
I am not sure. Tony has an auto TX version I think. But some manual
TX bell housings can also be used. I am sure the RX8 has new and
different bell housings becasue the six speed manual TX is new.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.