> I have been watching this thread with great interest as I also
> intend to
> P-port my engine (to be installed in a BD-4).
>
> Many pictures I have seen of P-port engines have the port cut at an
> angle
> that more closely matches the angle of the trochoid. Would it be
> possible
> to bore the hole at an angle such as this and still get the port
> timing
> needed for our application? This would allow a stepped bore
> without a gap
> that needs filling. The insert could then be a press or slip fit
> and still
> have the surface area to eliminate the possibility of leaks.
>
> Bryan
>
> Yes Bryan but I will not guarantee you will get the same
> power as the Lemans engine that had a straight in bore more
> or less. I don't expect it will be very much different however.
> --
> Paul Lamar ...No rotor no motor.
The angle make the rest of the intake too high above the engine to
fit inside most cowls and also 90º and 180º bends will not work when
you are constructing the intake. Jerry
Possibly.
The BD4 cowl is kind of tall I think. What say you Bob White?
He could cut a 180 degree bend off at the proper angle so the
upper leg was horizontal. Might be low enough.
Paul Lamar
The Cowl on my BD-4 is very tight as the engine sits pretty high to get
the thrust line in the correct place. It probably wouldn't hurt to
lower the thrust line a little. The Tailwind guys put move it all over
(right Jerry?), but lowering it would limit the length of the prop
somewhat. I have lots of room on the bottom.
Bob W.