OK folks here is a suggested test device.
I'll make the end caps on my lathe and JB Weld
them to the tube section. I'll install a tubeless tire
valve to pressurize it and a pressure gage fitting
on the other end. Then I will boil it for a couple
of hours, pump it up and see if it leaks.
Then put it in the freezer for a few hours. Take it out and
pump it up again and see if it leaks.
Can anybody think of any changes in the configuration
they would like to see?
--
Paul Lamar ...No rotor no motor.
Paul,
Put anti freeze in the tube, then pressurize and boil it since that is
what it will be sealing, not just pure water. I tried to seal a leak in
an auto AC system with JB-Weld and the R-134 would leak through in a few
hours.
Ed. Sadler
Paul
Also drill a hole in the pipe and plug it with JB Weld to simulate
the void in the housing where you found the leak.
Doug Fir
That would not be a good simulation of the problem area.
As I said before there is a lot of JB weld between
that spot and the water. That path is close to an inch
long.
I am near an elegant solution to that problem area.
It will required an NC mill. Later today.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.