Subject: Stright out with outside scoop.
From: Rotary Engine
Date: 9/17/2006, 2:59 PM
To: AA-me


Actually the BD-4 has very little room above the engine when placed at the
designed thrust line.  I was considering the fact the there is a very large
amount of space in the sides of the cowl (42" wide at firewall).  I could
route the intake out to the left then forward into a ram air box plenum.

Waiting with great anticipation for the results on Mark's engine.  Hope he
does get a smoother idle otherwise I will just use a throttle body at the
plenum.  This would be much easier to fabricate and based on the dyno
results with the Weber carb at 24" the performance should not be an issue at
6000-7500 rpm.

Bryan

Sure that would work. Here is an old 3D and pictures.
Like Daves but up higher.

The idle will be worse with a P-port and plenum than with a slide
throttle mounted close to the rotor housing. The reason is bad gases
are stored in those long runners when the throttle is nearly
closed.

-- 
Paul Lamar ...No rotor no motor.

What are the aerodynamics of that ram air scoop? With my ignorant eye it
looks pretty high drag.

Doc

No worse than an ME109 or P38.
At low speed it is negative drag as the engine is sucking
the airplane along so to speak :)

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.