Subject: 2 step flange and O-rings]
From: Rotary Engine
Date: 9/18/2006, 8:35 PM
To: AA-me



         > Yeesh..  This discussion has been going on.
         >
         > I haven't seen this idea proposed yet:  Make the p-port
   insert tube
         > double stepped, and the bored hole in the housing stepped to
        match.  One
         > step close to the rotor face, and the other step close to the
        exterior
         > surface of the housing.  Use a flange on the insert.  Drill
   holes
         > through the flange into the housing.  Tap the holes in the
        housing.  Add
         > o-rings around each step on the insert.  When the insert is
        clamped into
         > the housing by screws, the o-rings contact and seal against the
        steps in
         > the housing...  Low precision required.  Good resistance to
   thermal
         > cycling.  Inspectable and rebuildable.
         >
         >
         > Regards,
         >
         > Matt-
         >
         > Matt the inside of the water jacket in this area  is very
        complicated.
         > Aluminum material is probably missing where you need it.
         > This may or may not work. You need to make an accurate  scale 3D
         > or experiment with a junk rotor housing.
         > --
         > Paul Lamar ...No rotor no motor.

        Matt,
        Yep! Your right Matt - good ideas!! however it would probably
        require the
        insert tube to be at angle and as Paul suggested it may not be as
        nice and
        direct a shot as straight in, maybe some turbulence - but not
   enough to
        worry.
        Will It work !? That outside hole is getting much bigger however.
        George ( down under)


   Paul,

   You posted some pics a while back of a housing that had been bored to
   accept the p-port insert.  Please repost them..


   Thanks,

   Matt-

   OK Matt but you guys need to prove these ideas before anybody
   changes the way we have been doing it for the last 30 years.
   Send me some 3D's of what you have in mind.

   Paul Lamar ...No rotor no motor.

Thanks Paul...  Fair enough.


Matt-



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.