Subject: 2 step flange and O-rings
From: Rotary Engine
Date: 9/18/2006, 4:10 PM
To: AA-me



Yeesh.. This discussion has been going on.

I haven't seen this idea proposed yet: Make the p-port insert tube
double stepped, and the bored hole in the housing stepped to match. One
step close to the rotor face, and the other step close to the exterior
surface of the housing. Use a flange on the insert. Drill holes
through the flange into the housing. Tap the holes in the housing. Add
o-rings around each step on the insert. When the insert is clamped into
the housing by screws, the o-rings contact and seal against the steps in
the housing... Low precision required. Good resistance to thermal
cycling. Inspectable and rebuildable.

Regards,

Matt-

Matt the inside of the water jacket in this area is very complicated.
Aluminum material is probably missing where you need it.
This may or may not work. You need to make an accurate scale 3D
or experiment with a junk rotor housing.
-- Paul Lamar ...No rotor no motor.

Matt and Paul,

Matt's thinking isn't bad though. I have been working on this idea,
(stepped tube, with or without exterior flange), for a while. We would
all like to make a repeatable safe PP system. The answer may lie with a
combination of the two ideas. A stepped tube with a tight fit (not
pressed in) coated with epoxy on insertion. This seems a good
possibility. I don't like the potted system since it isn't a sure thing
either, and it can be difficult to determine the source of the leak.
Bill Jepson

Bill,
I liked Matt's idea - what do you think about using the"O"-rings. The
problem I see is the uneven outer surface (depressions) - as there is really
little aluminum in the outer skin to allow a further "O"-ring  recess, let
alone sufficient room for screw threads which most probably have to
penetrate the outer skin and the possibility of bolt holes becoming leaks
themselves.
There is a possibility of using a two piece insert, but it starts to get a
bit more difficult, it's got to be simple, reliable and repairable - given
it's not integral like the factory P-ports.
George (down under)

Would you guys please get off this subject. We had a pin hole leak
for@#$%&^* sakes. When you do some good 3D's let me know
or better yet build a p-port engine and run it.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.