Subject: 2 step flange and O-rings
From: Rotary Engine
Date: 9/18/2006, 4:22 PM
To: AA-me



 Yeesh..  This discussion has been going on.

 I haven't seen this idea proposed yet:  Make the p-port insert
       tube
 double stepped, and the bored hole in the housing stepped to
       match.  One
 step close to the rotor face, and the other step close to the
       exterior
 surface of the housing.  Use a flange on the insert.  Drill holes
 through the flange into the housing.  Tap the holes in the
       housing.  Add
 o-rings around each step on the insert.  When the insert is
       clamped into
 the housing by screws, the o-rings contact and seal against
       the steps in
 the housing...  Low precision required.  Good resistance to
       thermal
 cycling.  Inspectable and rebuildable.


 Regards,

 Matt-

 Matt the inside of the water jacket in this area  is very
       complicated.
 Aluminum material is probably missing where you need it.
 This may or may not work. You need to make an accurate  scale 3D
 or experiment with a junk rotor housing.
 --
 Paul Lamar ...No rotor no motor.

       Matt,
       Yep! Your right Matt - good ideas!! however it would probably
       require the
       insert tube to be at angle and as Paul suggested it may not be
       as nice and
       direct a shot as straight in, maybe some turbulence - but not
       enough to
       worry.
       Will It work !? That outside hole is getting much bigger however.
       George ( down under)



   Paul,

   You posted some pics a while back of a housing that had been bored
   to accept the p-port insert.  Please repost them..


   Thanks,

   Matt-


Nevermind Paul, I found some of the pics I was looking for.  I can see
the trouble now.  There really isn't much meat to work with there.
Probably could do the stepped thing on the interior side of the housing,
but would be tough on the exterior side..  Dropping (or was that
dripping) it.  :)


Regards,

Matt-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.