O.K.
Laura called me today form Real World and said yes Tracy will extend
the shaft to accept the bell housing @ $210.00 not to bad but not
great either. Now what I want to know is, is that a good idea? that
shaft seems a little hard. I'm thinking the cuppling I made may work
better. I'm thinking the length of the shaft that is on there is fine
short. Could there be a problem with additional stress with the extra
4in" of hardened steel shaft as opposed to say a 4in" aluminum
extension? Or is it a non issue? thoughts?????? anyone!!!!!
If the shaft length is O.K. with the additional 4in" I'll order it
on Wed.
I'm thinking though that if someone allready has a short shaft PSRU
and wants to use the bell housing the aluminum exstension may still
be a good way to go.
Tony
IMHO best way to go. No change in stress.
Paul Lamar ...No rotor no motor.
Tony,
Yeah, I was hoping for a price point around $100 or less. But, still
not too bad, especially when considered as a % of the overall cost of
the the gearbox. I think there is near zero chance that this will cause
an unexpected dynamic stress. Is the required extra length exactly 4"?
Aubrey
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.