> O.K.
>
> Laura called me today form Real World and said yes Tracy will extend
> the shaft to accept the bell housing @ $210.00 not to bad but not
> great either. Now what I want to know is, is that a good idea? that
> shaft seems a little hard. I'm thinking the cuppling I made may work
> better. I'm thinking the length of the shaft that is on there is fine
> short. Could there be a problem with additional stress with the extra
> 4in" of hardened steel shaft as opposed to say a 4in" aluminum
> extension? Or is it a non issue? thoughts?????? anyone!!!!!
>
> If the shaft length is O.K. with the additional 4in" I'll order it
> on Wed.
> I'm thinking though that if someone allready has a short shaft PSRU
> and wants to use the bell housing the aluminum exstension may still
> be a good way to go.
>
> Tony
>
> IMHO best way to go. No change in stress.
>
>
> Paul Lamar ...No rotor no motor.
>
>
Tony,
Yeah, I was hoping for a price point around $100 or less. But, still
not too bad, especially when considered as a % of the overall cost of
the the gearbox. I think there is near zero chance that this will cause
an unexpected dynamic stress. Is the required extra length exactly 4"?
Aubrey
Well it's close to that. I won't know exactly how long until I get
back over to the hanger and do some real measuring, not just eyeball.
I'll have it down to +/- .002 after I get it all measured out.
the other thing that I noticed about the redrive is the bolt heads
on the back of the mounting plate that hold the redrive on, they
really should be countersunk into that plate, this way there is no
need to modify the hole in the bell housing. So I think I wil start
with a hole new plate a little thicker so when I countersink the bolts
it will be back to it's original thickness at the bolt head.
Diameter of the plate is 8 5/16 to go on top of the bell housing
don't know the thickness yet.
Tony
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.