Yeah!

Paul that didn't work so well, the background Bitmap. If you
don't want to send me the Rhino of the redrive can you dim the
redrive for me and send as a jpg  the other thing I really need
to know is largest diameter and the smallest diameter oif the redrive.

thanks Tony

People don't do dimensions anymore. Dimensions are obsolete :)
It goes from Rhino file directly into the NC mill through
a couple of software stages.

What did you do wrong on the back ground bit map ?

You load it in on the side view. Draw a line 14.5 inches
long and scale the bit map so the length of the drive
from the rear housing to the flange is 14.5 inches.

This is a bit map drawing of a bell housing superimposed on Tracys'
drawing of the adapator plate. Works perfectly.

I would do it for you but my Rhino computer is at the hangar.
Hang on... I go there and get it. I'll need it here at the house
anyway.

-- 
Paul Lamar ...No rotor no motor.

OK Tony here they are.


Paul Lamar ...No rotor no motor.