OK here are the 3D's dwg's. The first two illustrate the problem but
are not entirely accurate. The hole is much smaller than shown.
This is due to an approximate 3D model of the rotor housing.
It is close enough however to illustrate the problem
The rest are the simple fix.
Paul Lamar ...No rotor no motor.
Paul,
Very nice drawings indeed.
Clearly shows the problem with a straight in tube, which doesn't go all the
way through.
I did the rounds locally and spoke to all the experts and looked at their
inserts and immediately recognized the potential problem as so clearly shown
in your drawings. I assume that's why the angled insert was used by some.
One could step the port hole and reduce the tube at the end, but adds to the
complexity for the do it yourselfer
Your inside SS insert does address that problem, but I ask myself why not
just use a thin SS insert from the get go!? Maybe your considering the
expansion rate difference - perhaps the silicone potting will address that
perceived problem.
A thinner tube has the advantage of not taking up so much apace, I had a
look at some Titanium pressure tube (1.2mm), actually have some at hand and
thought it would be ideal if I could get some the right diameter - SS would
do the same job this would eliminate the stepped option and would eliminate
the need for two tubes.
George (down under)
I am still looking for some thin wall SS tube.
Probably pretty easy to tig weld over a slotted steel mandrill.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.