Doug, here is why you are wasting your time fooling
with the p-port opening shape. The vast majority
of the time the port is wide open due to the distance
between apex seals on the rotor face. All you
can change is the exact slope of the opening curve.
I marked in red roughly the slope of the round port.
Now what is not mentioned in this chart is the aerodynamic
advantage of the p-port over the combo port. Yes
the combo port has more area but area is not the whole
story. The air must make some sharp right angle turns to
get through a combo port. A p-port straight shot into the intake
chamber counts for a lot... aerodynamic ly speaking. Air speeds
here are as fast as mach .4. This is why p-ports rule.
Also I believe this chart was for a 12 A. A wider rotor
13B gives more area advantage to a p-port. A 16B p-port
will be awesome to behold for given opening degrees.
A side port 16B will not be all that great as far
as high RPM power is concerned. It will indeed have
more low RPM torque. No replacement for displacement
when it comes to low RPM torque.
It is common sense however that a round port is easier on
the apex seals than a square or rectangular port would be.
Yes if you are a racer and you don't care about 3000 hour
life for your apex seals and you want the last little bit
of power a rectangular port might be the way to go.
Races are won on very small percentages. If you are six inches
ahead at the end of 24 hours you beat the next guy.
What percentage is that?
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.