The mill will be ready in two weeks.. :-) Thats what I've been  saying since
I started it anyway... In reality its going to be a little while  yet. I've
been working on it since the first of march. It's a bit tough to  set any
real date as its the 'issues' you find that make it long or short. Working
through them takes time.  It is a monster.. the working envelop is  18 x 8.5
x 4  all in feet, hence the time to get it all up to speed is a bit longer
than normal. I didn't get to work on it much this summer so that has
dragged it out as well.

In the mean time I'll have to start a list of Makes and models  which people
want, and then make some CAD models to make them all work. I've  done some
Rv10 cowl models in the past when the smily type opening was  thought to be
the optimum. W/ this new style it will take a 1 or 2 tweaks to get  it just
'so' but it shouldn't be a problem. Attached are some of the pic's  of the
old style cowl..

Jarrett

Remember that the S-beam has been moved down and back.    It is 30.5
inches wide and takes the first 3 inches of the pan flange.  Where
are you located, Jarrett?      Jerry

Yes, those pictures are a bit dated. I haven't taken the time to go back
through
the model and make updates to the current standards. It's just never been
much of a priority since I did them [at least until now :-) ]

I'm located about 30 miles north and 25 miles east of the Border junction
of ND,MT and Canada.

Jarrett
[Weyburn,Sask,Canada]


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.