Paul,
I recently had a chance to snag a complete LS-7 coil
pack set with the
D-585 coils. Here are a couple of photos of how it
would fit if
mounted near the 13b. There is substantial benefit
gained by leaving
the coil pack intact. The wiring harness is
vibration proof and
requires wiring to only one connector. The spark
plug wires have the
impedance matching spring and EMI shield on them.
The weight including
the wires is approximately 5 lb. Here are the
numbers on the individual
parts:
Wire harness: 6071
Mounting bracket for all four coils: 4201504
Coil: L34A29 over 1057 two coils, and R34A29
over 1057 other two
coils (The four coils are identical in appearance.
One coil has a
sticker marked 4A29), the steel mounting clamp
around each coil
19005218
Plug wire: coil boot Delphi 403, wire AC Delco
9079, no marking on
spark plug end
harness plug coil end: Delphi PBT (4 conductors:
Bk, Br, Pnk to all
coils, then Rd, Bl, Gn, Vio to respective coils)
harness jack main connector: no id marks (7
conductors)
inventory tag?, tape wrapped on harness: 15423372
weight complete: approx. 5 lb
Aubrey
The big question is are they going to live being
pulsed
twice as often as on the V8? We need to set up a
test rig
and measure the temperature rise on the coil as a
function
of pulse rate. The rotor fires once per rev while
a cylinder fires once every two revs.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.
paul,
i would like to know why gm decided to use single
coils per cylinder, was it performance reasons or just
for marketing? on their 4 and 6 cylinder engines they
use waste spark coils, one per every two cylinder, so
they do spark every revolution. and of course the old
v8 distributer engines used a single coil sparking 4
times per revolution.
as you've written before the big difference between
automotive and aircraft is that the automotive engines
are designed to only run at low power low rpm for
extended times versus the high power high rpm use in
aircraft. i suspect, as was mentioned before, that
putting the coils in a cool air stream will take care of
any potential heating problems. in auto use these
coils sit under hood in a very hot area.
gary
The new one plug per cylinder coils are a lot smaller than the
old big and heavy dist coil enclosed in a metal container
containing oil.
Those old engines had red lines of 4500 RPM.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.