Paul,
I recently had a chance to snag a complete LS-7 coil pack set with the
D-585 coils. Here are a couple of photos of how it would fit if
mounted near the 13b. There is substantial benefit gained by leaving
the coil pack intact. The wiring harness is vibration proof and
requires wiring to only one connector. The spark plug wires have the
impedance matching spring and EMI shield on them. The weight including
the wires is approximately 5 lb. Here are the numbers on the individual
parts:
Wire harness: 6071
Mounting bracket for all four coils: 4201504
Coil: L34A29 over 1057 two coils, and R34A29 over 1057 other two
coils (The four coils are identical in appearance. One coil has a
sticker marked 4A29), the steel mounting clamp around each coil
19005218
Plug wire: coil boot Delphi 403, wire AC Delco 9079, no marking on
spark plug end
harness plug coil end: Delphi PBT (4 conductors: Bk, Br, Pnk to all
coils, then Rd, Bl, Gn, Vio to respective coils)
harness jack main connector: no id marks (7 conductors)
inventory tag?, tape wrapped on harness: 15423372
weight complete: approx. 5 lb
Aubrey
The big question is are they going to live being pulsed
twice as often as on the V8? We need to set up a test rig
and measure the temperature rise on the coil as a function
of pulse rate. The rotor fires once per rev while
a cylinder fires once every two revs.
Paul Lamar
------------------------------------------------------------------------
Paul,
I agree. I'll try to scrounge up enough equipment to test one of
them. Do you know if the trigger signal is TTL compatible? Gary, I
think the main motivation (for cars) in going with separate coils is to
eliminate the mechanical distributor. Historically, one coil ignition
systems on V8's would run out of "oomfph" at around 5000 RPM. That
would have subjected the coil to around 300 pulses per second. At 7500
RPM our coils will be subjected to around 125 PPS. So, it would be
easy to conclude that they would be reliable. But, the output of these
new systems is far greater than the old one coil systems and as Paul
mentioned, they are smaller. So, we need to run some tests to confirm
our expectations. A few weeks ago I changed the plugs in my Chrysler
3.8L V6 with 73000 miles. One of the plugs was astonishingly different
from the others. As soon as I can find a way to make some extreme close
up photos of the plugs, I'll share the story with the group. But, for
now, I'll just say that my understanding of these systems was changed
quite a bit by what I found. The coil, plug wire and spark plug,
apparently, form a tightly coupled system that has been developed with
a lot of R & D hours. So, one of the things I'd like to test is what
happens to the thermal load on the coil when we change to a different
spark plug or a different plug wire.
Can anyone fill in the blanks for pins 1, 3, & 4 on the pin-out for this
coil?
Aubrey
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.