> > >
> > > Paul
> > >
> > > I contacted a a transmission shop they have plenty of 3rd Gen
> > > manual non turbo bell housings but that bell housing pic is
> > > from what he says is a Turbo manual trany, those are very hard
> > > to come by plus they don't sell that tranny without the bell
> > > housing. Can we verify if that is for a turbo or non turbo motor?
> > > that seems to be the biggest issue with these bell housings.
> > >
> > > Tony
> > >
> > > All third gen RX7 are turbo's. I don't think he is all that
> > > familiar with rotaries. Try E-bay or new.
> > >
> > > Here is the second gen manual TX bell.
> > >
> > >
> > > ------------------------------------------------------------------------
> >
> > Tony,
> > The Cosmo bell housing has a depth of 167mm = 6.6 inches. So, it is a
> > little deeper than the 2nd gen manual housing that Paul has pictured.
> > The Cosmo weighs 13.0 lb and Paul measured the 2nd gen manual one a few
> > months ago to weigh 7.5 lb. Another consideration is whether the flex
> > plate that fits Tracy's resilient spline adapter will mate with the
> > starter gear if you change to a different bell housing. The Cosmo flex
> > plate has a larger diameter and does not fit Tracy's spline adapter.
> >
> > Aubrey
> >
> > So too the 3rd gen man has a larger ring gear. Question for
> > Tracy.
> > --
> > Paul Lamar ...No rotor no motor.
> >
>
>
> Well I think if you use the corresponding flex plate that is used
> on the stock bell housing that you acquire it shouldn't be an
> issue at all. The starter is at the correct depth but you still
> have to order the proper length shaft on the redrive. The reason
> you have to use a certain year flex plate now, is obviuos because
> the redrive shaft is a preset depth. As far as the spline drive
> bolting up to all years of flex plate is still an unknown but as
> far as I can tell that spline drive plate is the easiest part of
> the entire unit to recreate if the mounting holes need to be
> repositioned. here is a pic of the bell housing it's 7 1/4in
> deep,
>
> Tony
>
> Tony I called John. The third gen man tx bell is a little
> less than 6.25 inches deep. The dia of the ring gear IS
> an issue.
Paul Lamar
Paul maybe I'm not seeing the full picture here what is the
issue with the larger ring gear? I'm guessing it's the spline
drive hole location where it bolts to the flex plate is that
right or no?
Tony
For some strange reason some ring gears (Years transmissions) are
larger than others. This makes the bell housing different as well
as the starter must be positioned in the right place
to properly engage the ring gear. So you must get the right
flex plate for that bell housing. Since the 3rd gen bell is
a manual TX there may be no flex plate that works with it.
You might need a custom flex plate with a flywheel ring
gear.
--
Paul Lamar ...No rotor no motor.
I see! well the bell housing I have is an 89 auto with an 89 flex
plate so it should work for me. I think I have a source for the
3rd gen bell housing but he wants $350 shipped so I'll keep
looking or see if i can get him down to 150 or 200 per housing.
Tony
That sounds like a new price. You might check with a dealer
or Mazdatrix on the new price.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.