This is for those people that want to save a couple hundred
on a custom oil pan and use a stock oil pan. This is near
identical to the way the Questair bed mount is done for the
air cooled Cont. IO-550 AC engine. This bolt pattern is for an
RX8 engine but the same idea is used for a 2nd gen or 3rd gen
engine.
What does everybody think of this? In particular what
do you think Jerry? Does it add so much to the cost that
a custom aluminum oil pan is still worth while?
Paul Lamar ...No rotor no motor.
Paul,
I was going to suggest something like that, it seemed a natural progression.
The problem in the past with bed mounts was that there is an additional
joint and with the flexing there is leaks. My suggestion was that the bed
mount go under the oil pan with only the one joint - and I'm assuming that
is exactly what your drawings depict.
George ( down under)
Yes. Same as the Quest air venture. Under the oil pan.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.