RE> Hello Paul,
RE> I have decided to use a different fuel and ignition system on the
RE> Renesis in the Mustang2. I have decided to use throttle injection
RE> bodies as I have been impressed with the performance of the one I
RE> am running on my Jabiru 3300. Therefore I have one EC2 and a LCD
RE> EM2 for sale. This is the large panel. I will build an ignition
system
RE> similar to the Jabiru. I'v done a lot of work on the new system
and am
RE> happy with the results so far. I plan to dyno the engine after all
the
RE> mods are done. I am also waiting for the new weight that RAA in
RE> Australia are pushing for with CASA. I will not go through
RE> registration until it is clear and the new regs are out.
RE> Best regards,
RE> ddunbar mailto:ddunbar@echidna.id.au
RE> Do you have any pictures of those TIB's Don?
RE> Paul Lamar
Hello Paul,
They are from Revmaster. I have one on the Pulsar with the 3300 Jabiru
in. It took some tuning but I was going through a learning curve. What
I know now it would take no time to tune.
The little bird photo is for Robbin.
Friday, September 29, 2006, 9:57:19 PM, you wrote:
Best regards,
ddunbar mailto:ddunbar@echidna.id.au--
Thanks for the pictures Don.
What are you going to use for the center ports?
Those TIB's might be useful for P-ports.
Paul Lamar
On second thought the 40 mm (1.57") size is still marginal
for a p-port. The price seems right however at $320 for
a 34 mm version. Too bad he does not make a 51 mm version
for P-port rotaries.
http://www.revmasteraviation.com/products/revflow_injector_carburetor/index.htm
Paul Lamar ...No rotor no motor.
Hi Paul;
One thing people could do is to provide a taper after (and possibly
before) an undersized
carb or any other restriction in the intake system. This should be able
to recover most of the
losses in the system due to the restriction as long as the sizes are not
too far apart. 40 to 51mm
should be do-able.
Hoerner rule is roughly 6 degrees or a slope of 1/10. This would be
(51-40) = 11mm/2
= 5.5mm x10 = 55mm=~2.2in length for the taper - I have heard talk of
slower tapers
but never results.
Cheers
Cary
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.