>
> Can you do bismaleimide resin. ?
> and what resin are you using in your hot sections? is heat soak ever a
> problem in F-1
>
> Tony
Tony,
I have not used Bismaleimide resin. I could, but see no real reason to
switch to this from the system I use presently as it has a very good high temp
property as long as it's cured at that temp. The gearbox should not see any
higher temp than the engine oil temp, which should not go over 225F for both
engine and box to stay alive in an aircraft. I know a rotary can have high oil
temps if not dealt with, but a bearing is a bearing and won't tolerate too high
a lube temp, so the box should be kept cool as well. A carbon box will work
well as long as it is kept under it's cure temp by a safe margin, I can cure it
at 350F if needed.
Quoting "" <tonyslongez@cox.net>:
> Dave
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.