Al
Al, got any pictures of your new cooling air scoops?
Paul Lamar
Not really any new scoops yet; just a temporary sheet-metal addition to form
a ram scoop for the oil cooler inlet, with a couple sets of vgs out in
front. It works, but I want to work on reducing pressure at the exit on top
of the wing as a possible solution of less drag. The large scoop you see up
against the side of the fuselage is doing a fine job for the coolant system,
while the other smaller radiator in the other wing is doing very little.
Al
Should not need the vortex generators there. The boundary layer
should be pretty thin that far forward under the wing
where high pressure prevails.
Please keep us informed. Very interesting configuration.
As I recall you are running a Griffin oil cooler with the
new extruded aluminum tubes. Same as Mistral. What is the
depth of the core portion. IMHO those tubes do not
transfer heat from the oil to the aluminum tubes as well as the
stock 2nd gen RX7 Moline oil cooler. The Moline has a bunch of
oil turbulators inside the tubes.
Also what weight oil are you using? Apparently heat transfer
rate from the oil to the aluminum is a function of the weight AKA
viscosity. The RX8 engine specifies 5W-30.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.