This is from a booklet titled Automotive Composites 2nd edition
published by High Performance Composites magazine which
I have a subscription to.
This is very similar to what we are trying to do with
a carbon composite bell housings and motor mount combo.
The wall thicknesses are also similar to what I suggested
for the bell housings.
Note the 30 to 35 gear box consumption in a season
comment. So typical of professional car racing.
Paul Lamar ...No rotor no motor.
Is that 30-35 for one car, or for the team? It's not surprising they go
through a few gearboxes every year.. They have to put up with
tremendous load transients - shifting, spinouts. They crash the cars.
Given that the gearbox is part of the primary structure of the car, I'd
guess that it's rare for a gearbox to survive a crash (same for
airplanes). Considering that the composite gear boxes are obsolete
before they wear out (unlike the aluminum boxes), that sounds like a
good match for us.
An automotive gear box is increadibly complex compared to what we need.
I'd assume they contain a differential (transaxle). One input, two
outputs. They have to shift between multiple ratios very quickly,
usually without clutching.
Let's keep in mind upgrade paths.. I want to be able to run 500hp, and
have a prop governor pad.
Regards,
Matt-
Probably a team. Maybe as many as four cars.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.