Otherwise I may be stuck adapting the following systems:
Porsche 911 Bosch DI unit
Alfa Spica DI unit
also, the following maring two strokes now are using direct injection ..
Mercury OptiMax (V6 or 3 in line)
http://www.mercurymarine.com/153
Evinrude E-TEC 114 V4, 105CID
http://www.evinrude.com/en-CA/Engines/Showroom/ProductSpecs.htm?productID=ETEC115
Nissan TLDI NSD 115
http://www.nissanmarine.com/products/115_tldi_specs.html
Yamaha HPDI (V6)
http://www.yamaha-motor.com/outboard/feat_hpdi_2006.aspx
why Compression Ratio only 6.2:1?
I also like Mr. Lamar's idea of using exhaust heat / energy to help
turn the
eccentric shaft. Is anyone selling the parts necessary to pull this off
with a 13B engine ?
Thanks,
Bruce Toski
Bruce, Let me save you some grief anyway. While DI may not be any
panacea in rotaries, I am interested in it also. I have already
researched the Orbital DI system. This is the unit used on the Mercury
outboard and several others . This is NOT a true DI system. It is an
air-assisted injection system, not capable of injecting at over 3 bar.
The most interesting system I have seen is the one on several of the new
Audis and Volkswagons. Siemens markets it and it is a true high pressure
system capable of injecting at trueTDC. They are using a piezoelectric
injector with super fast response times. This looks like the hot ticket
as the system is already set up for both gasoline and diesel, and will
be made in some quantity which should help bring the cost down. I talked
directly to Orbitals rep/subsidary in the US Synerject and they were
only interested in dealing with OEMs. They wanted 10K to 30K for a
"starter unit" which I would have to program! I said, "Sorry I'm not
Chevorlet." Cheers and good luck,
Bill Jepson
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.