No problem Doc. I can give him Solid Works files which
   usually work better when doing NC stuff. Or Iges or dxf
   his choice.

   We now have two styles. Long travel 3 inches or short
   travel two inches. The long travel is an inch longer.

   Paul Lamar ...No rotor no motor.



   Why not just weld 3/8 bar stock for the frame rather than mill it out of
   one piece?  I made the flange for my oil pan by welding 1/4X1 1/2 and
   1/4X2 inch flat stock together.   Karibian

Easier still, use two short and two long pieces of square stock square
the ends tap and clearance holes and bolt on the ends. No welding
required. The front to back through bolts could be pre drilled in the bars.
Bill Jepson

They must be sealed Bill. You don't want raw fuel dripping out
on the exhaust. Best down as one piece.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.