Subject: Ducted fan airplanes
From: Rotary Engine
Date: 10/20/2006, 1:41 PM
To: AA-me



The 1300 pound thrust at sea level Williams engine is probably
developing one third of that at 30,000 feet or about 430 pounds.
TSFC (pounds burned per pound of thrust) for a small turbo fan
might be as low as 1.3 at this altitude so fuel burn would be
about 560 pounds an hour or 93 gallons
an hour. With 1120 pounds of fuel or 186 gallons on board
range at 450 MPH would be 900 miles. 4.8 MPG.  Every year
at OSH I would stop by the Williams booth and ask about
the TSFC every year they would not tell me :)

At 400 MPH or 586 FPS that would be  459 equivalent thrust HP.
At 450 MPH if it will go that fast 660 FPS or about Mach .5 In
that case the  equivalent thrust HP would be 516 HP net.

Rotary engine power required with a .6 eff. duct would be 860 HP.
Fuel burn at .4 BSFC (TC) would be 344 pounds per hour or 57 gallons
an hour or 8 MPG. Range would be about 900 miles with 120 gallons.

Cooling required would be a major design effort. Some of the
boost pressure would be diverted to pressurize the
cabin.

Its been done and I will upload some pictures shortly.


Paul Lamar


Paul,

I made a mistake in my arithmetic in my previous post.

At a fuel burn of 267 pounds per hour and a SFC of .7, the Williams
engine would be putting out 380 hp, not 185 as I incorrectly calculated.

This is equivalent brake horsepower not thrust horsepower. So it would
take the same amount of brake horsepower from a rotary engine, assuming
the efficiency of the duct was roughly the same. But I think the
efficiency of the engine-less duct would be better, so it might actually
take a little brake horspower than that to fly at that speed.

Regards,

Gordon.



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.