Subject: Ducted fan airplanes
From: Rotary Engine
Date: 10/21/2006, 6:27 PM
To: AA-me


Gordon wrote
Snip > For example the D-jet specs give a maximum range of 1350 nm at a
long-range cruise of 240 knots, flying at at FL250. This gives 5.6 hours
in the air, plus the standard 45 minute NBAA reserve, presumably. With
1700 pounds of fuel on board, this translates to fuel flow of just 267
pounds per hour, or 38 gph of Jet A, which weighs about 7 pounds per gallon.

Snip  (The D-jet maximum cruise speed is given as 315 knots, or 362 mph.)

The currently flying D-jet is a non-conforming proof of concept prototype
which has as much in common with a home built as with the eventual certified
design. You can bet those numbers above came from the marketing department
without much input from engineering.

While you might get a small A/C along at 275 MPH on 200 THP, unless you can
provide a lot more thrust for take off, you are going to be limited to
flights between Edwards, the great salt lake, and other 40 mile runways.
That little Williams fan will be absorbing somewhere above 800HP at rated
take off thrust.

While the drag racers are getting incredible HP out of the 13B, your 475HP
at take off and 285 continuous out of the 13B is very speculative for an
aeronautical use.

Paul wrote
Snip
Now a days the big engine manufacturers are still making significant
changes in turbo ducted fans due to the pressure to reduce air liner fuel consumption.

The big changes being made to the fans is the use of highly optimized 3D
aero CFD code. Even the baseline GE90 only had a 2D aero fan. The GE90 -115B
has a funky 3D Aero fan, as do the later Trents. GE introduced 3D aero
compressor airfoils to the GE90 and CFM 56 engines a few years ago, and I
understand the LP turbines of the GENx will also benefit from 3D Aero CFD
work. (The other big beneficiary of this work is Formula 1 racing. GE was
doing work for Ferrari in the late nineties, and they were the first to use
3D Aero wings).  The shapes they end up rather counter-intuitive, and I am
sure there is still a fair bit of engineering judgment involved in picking
the candidate shapes before running the models, so there is probably still a
couple of percent more efficiency still to be had here.

Mark Wrathal.

Mark W is a former Lauda Air airline engine engineer now working for
the EU FAA equivalent.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.