Paul, and Gordon,
Locating the engine near the CG with the shaft to the duct is
interesting. A perfect carbon fiber project. This is an area where I
must profess some ignorance, but I have a question. Will multiple
stages/fans improve the thrust of a non-engine shrouded small-diameter
duct? I realize this isn't done with the big turbofans, but they have
serious space considerations even discounting the weight of the fan
itself! Compressor stages are always multiple. Perhaps our speed range
is the culprit?
Bill Jepson
Bill,
I was thinking of a single-stage fan because it would probably provide
enough thrust. A second stage which would add weight and complexity, but
might be the way to go if you were planning on going really fast.
I'm not up on this stuff either, but I think you're right about
commercial planes using a single stage. I think some of the military
turbofans use a second fan stage, what with their higher speeds.
Regards,
Gordon.
remember that in turbines the design point is sufficient airflow and
pressure ratios for combustion. Non-turbine applications are effectively
super high bypass and the design driven by the airflow needs of the
duct/shroud.
George Wright
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.