Bill wrote:
Locating the engine near the CG with the shaft to the duct is
interesting. A perfect carbon fiber project. This is an area where I
must profess some ignorance, but I have a question. Will multiple
stages/fans improve the thrust of a non-engine shrouded small-diameter
duct? I realize this isn't done with the big turbofans, but they have
serious space considerations even discounting the weight of the fan
itself! Compressor stages are always multiple. Perhaps our speed range
is the culprit?
Bill Jepson
Mark W wrote,
you are looking for mass flow, not pressure rise, so multiple stages aren't
going to help you in this case.
Multi stage compressors are installed to increase pressure, as the greater
the compression ratio, the greater the cycle efficiency of the internal
combustion engine.
Propulsive efficiency peaks when the air you chuck out the back is going
just a little bit faster than you want to move forward. TurboJets efficiency
sucks until you get up well beyond Mach 1. The ever increasing bypass ratios
of turbofans is just an effort to increase propulsive efficiency for sub
sonic use.
The PW 8000, (and CFE) add a fan speed reduction gearbox, trading the extra
weight and complexity for the increased efficiency of a higher speed LP
shaft and big slow turning fan.
GE went as fan as dumping the fan shroud on the GE-36 UDF proof of concept
engine in the nineties. SFC was nearly 30% better (according to GE) but the
noise, structural fatigue issues, and low fuel prices at the time made it a
dead end.
With that you already have the bridge to turboprops.
Mark W.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.