No problem Doc. I can give him Solid Works files which
     usually work better when doing NC stuff. Or Iges or dxf
     his choice.

     We now have two styles. Long travel 3 inches or short
     travel two inches. The long travel is an inch longer.

     Paul Lamar ...No rotor no motor.



     Why not just weld 3/8 bar stock for the frame rather than mill it out of
     one piece?  I made the flange for my oil pan by welding 1/4X1 1/2 and
     1/4X2 inch flat stock together.   Karibian

Easier still, use two short and two long pieces of square stock square
the ends tap and clearance holes and bolt on the ends. No welding
required. The front to back through bolts could be pre drilled in the bars.
Bill Jepson

They must be sealed Bill. You don't want raw fuel dripping out
on the exhaust. Best done as one piece.

Paul Lamar ...No rotor no motor.

Doc,
I would be interested in the slide throttle.  I still have a great deal
to learn and figure out but am somewhat time limited.  The more I can
use production/available parts the quicker the project will go(I Hope!)
I am building a GlaStar on Alaska.  Renesis engine.

Paul Kvernplassen
building GlaStar in Alaska


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.