Subject: Ducted fan airplanes
From: Rotary Engine
Date: 10/23/2006, 1:16 AM
To: AA-me



   The PW 8000, (and CFE) add a fan speed reduction gearbox, trading
   the extra
   weight and complexity for the increased efficiency of a higher speed LP
   shaft and big slow turning fan.

   GE went as fan as dumping the fan shroud on the GE-36 UDF proof of
   concept
   engine in the nineties. SFC was nearly 30% better (according to GE)
   but the
   noise, structural fatigue issues, and low fuel prices at the time
   made it a
   dead end.

   With that you already have the bridge to turboprops.

   Mark W.

Mark,
I followed the UDF development with a great deal of interest. The
progression through the various scimitar shaped blades was very tough
sledding for the engineers. My comment about the fan-in-duct was
intended to improve the efficiency and conversion of the available HP
into thrust. While this whole idea may be only a "concept exercise" I
like to understand the physics of what is happening. If the induct air
was moving too fast for max efficiency couldn't you increase the duct
size by a fraction and improve it? Somebody familiar with ducted fans
could probably tell you the optimum size based on needed takeoff
thrust/designed cruise speeds with the telling factor that approximately
400 HP is the maximum available. You would probably find that there is
no practical size, and it's all just a head game anyway or it would
probably have been tried already.
Bill Jepson

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.