George./ Gordon
What would be wrong with a single Mazda rotor 80-130 hp at 240lbs ( all
up)
George ( down under)
George (down under),
A single rotor Mazda would also be a good choice for the Mini-Imp, as
far as I'm concerned. In fact I think all up weight could be well under
200 pounds because with the direct drive fan we don't need a 40 pound
gearbox.
Regards,
Gordon.
The big problem with a shaft drive, and a Mini Imp requires a
shaft drive, is the severe low frequency torsional resonance
problem. The prop acts like a flywheel on the end of a long shaft
and you are feeding it one huge torque pulse per engine
rev. Molt had his problems with a four cylinder engine
that puts out two smaller torque pulses per engine rev.
You ain't seen anything yet until you try a 1.3 liter single
rotor engine or a 650 cc single cylinder two cycle engine. Or even
a 1.3 L two cylinder four cycle engine. All put out one
large equivalent torque pulse per engine revolution.
http://www.prime-mover.org/Engines/Torsional/contact1/contact1.html
http://www.mini-imp.com/
Stick with a small all aluminum two rotor if you can find one.
Diamond aircraft is sitting on a great one if you can talk
the owner Christian Dries into selling them. (George P,
If you can send Chris a blanket purchase order for
100 a year I think he would go back into production.
Unlike Wankel Gmbh they have the inventory and the
where with all.)
It is as least as good torque pulse wise as a 4 cylinder.
Or better yet use the 200 pound 100 HP O-200 and run a decent
dia. more eff. prop. No liquid cooling system required.
Mazda Wankel engines are great but they are not the best
for all applications.
Paul Lamar ...No rotor no motor.
Gordon,
I was under the impression the bearings won't hold up in direct drive and
I've always thought along the lines of PSRU with dampening for the torque
pulses - that's how it's been with the two rotor and Tracy has done a good
job with the damper design, simple and effective.
The single has greater torque reversals that a 4 cylinder so may require a
different damper, perhaps something like the BMW damper.
I'm unfamiliar with the long drive shaft resonance problems, but with a good
design that may eliminated or dampened out ?
Just some thoughts on the subject as I don't think the single rotor has been
fully utilized to date.
There area few of us still working on regardless!
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.