Why would they be labor intensive say over a four cylinder
piston engine like a Rotax 912 or 914?
Paul Lamar ...No rotor no motor.
You were there Paul, remember the individually mic'ed and selected rotor
bearing rollers to make up a matched rotating assembly of very tight
tolerances. Assembly takes roughly 50 man hours. Then you have all those
sand cast parts which need machining operations (sometimes with multiple set
ups), although you are talking production of between 10 and 50 per year. The
engine was never optimised for mass production.
You can bet Rotax has standard automotive tolerances, and just puts the
things together with any parts from any batch.
Mark W.
Yes now I remember. That is because they are using roller
bearings for the rotor. I agree that is a dumb idea. It needs a
high pressure oil plain bearing system like the Mazda. I think we sent
the Diamond engineers email on that subject. Also the red line
would go up to 9000 RPM from 7000 RPM like the RX8 engine and
28 HP more power would be generated or 128 HP total.
Of course they would have to increase the
gear reduction ratio.
This fact probably never made it to Chris Dries.
OK people when you send him email mention this fact.
Diamond Chris Dries
<c.dries@diamond-air.at>
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.