Close to 50 pounds off the weight of your engine.
-- 
Paul Lamar ...No rotor no motor.

Paul,
Are they sand cast or high pressure injection cast?
George ( down under)

Sand cast. Jim Mederer is rich but not that rich:)
High pressure aluminum die casting molds are 3 or 4 hundred
thousand dollars each.

Paul Lamar ...No rotor no motor.

Paul,
They seem a little too good for a sand cast - might they be low pressure
investment cast, using a cast iron cast. They can pre-heat the cast (iron)
to allow for better flow of thinner sections of aluminum - the internal
void formers would of course have to be sand and it certainly looks that
way.
Just thinking out loud!
George (down under)


I am sure they are sand cast. I have seen the pattern. They are just
hand polished that's all. They may be using wax cores.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.