> Paul
>
> I want to put the stock tension bolts back in my motor but I don't
> want to make a mess squirting a bunch of silicone in the holes to
keep > them from vibrating. There has to be a better way. what about
using > heat shrink tubing? maybe I can build it up so the tension
bolts fit > snug in there respective holes.
>
> Tony
>
> Sounds like it is worth a try. Try a test sample. Heat it
> in the oven to about 220 F and see what happens to the
> heat shrink tubing. Silicone is good to 500 F.
Paul Lamar
Tony,
You don't need to squirt a bunch of silicone in the holes. Just put
about a 2 turn spiral bead along the bolt length and push it through.
This insures that there is more on one end than the other. The purpose
is to interfere with resonance mode vibrations that could possibly
occur. It doesn't take much silicone to do that.
Aubrey
Aubrey
I'm very aware of the reason for doing it. What I don't like though is
the
mess it makes when you have to take your motor apart not to mention,
(from what I understand) the silicone makes taking apart your motor
alot more difficult. Of course, this is secound hand information, it
sounds like it 's a plausible issue and it came from what I would
consider a reliable source. Seems like some heat shrink tubing will
do the trick and is much cleaner. I may just make some sort of mold
that I can squirt the silicone into that I can just slip it over the
tension bolt. Any ideas ?
maybe McMaster has something I can use.
Tony
Tony,
OK, here is an untested idea for you to consider: Scotch 23 self-fusing
electrical tape. It is an Ethylene Propylene rubber compound that has a
vinyl back that is peeled as the tape is applied. It fuses on contact
to form a continuous covering and has good vibration damping
characteristics. It maintains its electrical properties to 266F, so,
its physical properties are probably good to well beyond that
temperature. The tape thickness is 0.76mm, and you would need to lap
it, so, clearance around the bolts may be an issue. It can be stretched
and thinned somewhat.
On the other hand, if you choose a silicone gasket forming material that
is designed to have low adhesion properties, it will peel off easily and
will not bond the engine together.
Aubrey
Good idea Aubrey.
You can also get silicone rubber tape.
Here is a custom hose I made with it.
I needed some custom size thin wall hose for connecting the various
parts of my tunable intake manifold so I decided to make some.
Most hose comes in 1/4 increments and I was using pipe
instead of tubing.
Step 1 cut the form out of plastic pipe the right size.
Step 2 wrap the pipe form with 10 or more layers of
thick (3 mil) clear plastic. Hold in place with
scotch tape.
Step 3 wrap with one layer of teflon tape sticky side out.
Part number 3M Permacel P421 3/4
Step 4 wrap with one layer of red silicone tape.
Part number Versaitek Moxness 603 1 inch red sticky side out.
Step 5 cut two layers of fiberglass tape.
Step 6 wet out the two layers of precut fiber glass tape
with red RTV between layers of clear plastic. Strip off
the plastic and wrap the saturated fiberglass around the form.
Step 7 finish wrap one layer of red silicone tape sticky side
down.
It takes longer to describe the process than actually doing
it.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.